I have a stereo in the living room. A proper one, as in I-bought-it-from-Richer-Sounds proper. Yes, that does make me old-fashioned, but the kind of music I like wasn’t mixed to sound good on shitty little speakers, and I still like to buy music on CD. So there.

That said, I do have our whole CD library ripped to our Plex server for ease of access from our phones and cars while out and about, and for a while now I’ve had an Amazon Echo Input hooked up to the stereo and used Alexa’s Plex skill to stream music from Plex to the living room stereo.

It works well, but like many people I’ve started to worry about the privacy implications of Alexa technology. So, I started looking around for some alternative streaming solutions, and based on reviews and so on eventually settled on the TIBO Bond Mini as offering everything I needed except voice control, for a reasonable amount of money.

The first thing that struck me when I opened up the box is just how dinky the thing is – it’s little bigger than a ring box. Setup is, according to the quick start guide, a matter of hooking it up to the stereo, powering it on and following the steps in the companion app to hook it up to the wifi network. Simples.

Or so I thought. Here is where I hit my first snag. It seems that the Bond Mini doesn’t support 5Ghz wifi. My home wifi is dual band and uses the same SSID for both, because the mesh system allows 5Ghz devices to fall back to 2.4Ghz in some of the dodgier areas (old house, thick brick walls, therein hangs a tale ….).

Happily it offers an alternative means of setup. You can use your phone to join a temporary wifi network fired up by the Bond Mini and configure it from there.

Except that, of course, my phone is too bloody clever by half, realises that the temporary wifi network doesn’t have internet access, and falls back to 4G. The only way to get around this seems to be to put it into flight mode and then manually re-enable wifi. With that done, the app could at least see the device, but the device apparently couldn’t see my home wifi network and so the setup wizard couldn’t continue.

There is a third and final way offered to configure it, which is again to hook up to the temporary wifi network and then configure the device manually using its web-based interface. Finally, that worked and I was able to get the thing onto my home network.

It then resolutely refused to see my Plex server through DLNA. I even went so far as to give the Plex server a restart. No joy. So, I restarted the Bond Mini, whereupon the control app stopped seeing it and it apparently completely forgot the wifi config and went back to first setup mode.

It being a school night, I gave up at that point. I will have another go this weekend, but I have to say, first impressions are less than stellar.

UPDATE 29/09/19: I’ve managed to get it onto the network reliably. Still won’t see any bloody DLNA servers though. Gah. I’ve contacted support. We shall see.